Teardown, Repair & Analysis of a Noise-XT 2MHz – 7GHz Ultra-Low Phase-Noise Synthesizer

In this episode Shahriar repairs a Noise-XT 2MHz – 7GHz Ultra-Low Phase-Noise Clock Synthesizer. The instrument’s history indicates that it has suffered a fall from a work table. After a lot of difficulty, the instrument control software was found so that the unit can be tested.

Initial tests reveal that a very small output is present, however nearly 40dB below the desired value. The unit teardown shows an architecture based on dual Analog Devices DDS 14-bits DACs in conjunction with a Z-COMM VCO and a series of dividers & frequency multipliers. A detailed analysis of the unit is presented.

RF and analog measurements indicate that the RF connector is not making adequate contact with the final trace of the RF output. This explains the low output power. This problem is resolved by replacing the SMA connector entirely. The device output power, frequency accuracy, stability as well as cross-correlation phase-noise measurements are presented.

 

One comment

  1. V says:

    Thanks. Good presentation.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

  • Social Media

    twittergooglepluswordpressyoutuberedditrssemail
  • Administrator

  • Archives

This site is protected by Comment SPAM Wiper.