Teardown & Repair of an Agilent N9020A MXA 10Hz – 26.5GHz Spectrum Analyzer (March 2020)

In this episode Shahriar takes a look at a malfunctioning Agilent N9020A MXA. This instrument was provided by AllTest who hold the largest inventory of used and refurbished instruments. They have trusted The Signal Path to attempt a repair on the instrument and to support the educational content of this channel. Thank you AllTest! Please visit their website for all your measurement, calibration and service needs:

sales@alltest.net
https://alltestchambers.net
https://alltest.net

The instrument fails RF Alignment despite the fact that all calibration signals are present and can be viewed on the unit. The front-end attenuators also appear to be fully functioning. A full sweep of the input shows that the instrument fails to make measurements between 8.4GH – 14GHz as well as above 17GHz. The block diagram is analyzed and the likely fault is traced to a doubler circuit on the A13 RF Assembly. The teardown of the assembly along with step-by-step reverse engineering is presented. An X-Ray of the module also reveals the hidden band-pass filter structure on the PCB. Various dies are also examined under the microscope. The A13 module is replaced with which corrects all the instrument faults and returns the unit to normal operation.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

  • Social Media

    twittergooglepluswordpressyoutuberedditrssemail
  • Administrator

  • Archives

This site is protected by Comment SPAM Wiper.