Teardown & Repair of an Agilent N5182A MXG 100kHz – 3GHz Vector Signal Generator

In this episode Shahriar repairs a malfunctioning Agilent N5182A MXG Vector Signal Generator. While the instrument operates perfectly above 250MHz, below 250MHz the output is very low with a significant increase in the noise floor.

The block diagram of the synthesizer is presented showing various RF signal paths. It is shown that the sub-250MHz band is derived from a hetrodyne section which is where the problem located. Using a EM probe, various signal flows are discovered on the main board and compared with the block diagram. The main problem is traced to a doubler circuit which generates a 1-GHz LO signal for the hetrodyne section. The doubler comprises a transformer coupled to a dual diode surface mount IC. The IC is replaces which restores the doubler functionality and repairs the instrument.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

  • Social Media

    twittergooglepluswordpressyoutuberedditrssemail
  • Administrator

  • Archives

This site is protected by Comment SPAM Wiper.