In this episode Shahriar demonstrates one of the simplest magnetic levitation circuits. First, the basic concept of magnetic levitation is examined. Two different methods of detecting the location of the levitating object is presented and the Hall effect sensor method is chosen. A semi-digital overall system is implemented where a PWM control IC is employed to control the magnetic field strength. The block diagram and functionality of this IC is presented. Finally, the schematic of a dual-Hall effect sensor solution is presented. The circuit is built and tested in both open-loop and close-loop configuration. Magnetic levitation is demonstrated with the capability of adjusting the levitation location. The schematic of circuit can be downloaded here and the electromagnet can be purchased from here.
In this episode Shahriar investigates some state-of-the-art energy harvesting ICs from Linear Technology. The LTC3105 is a highly efficient 400mA Step-Up DC/DC Converter with Maximum Power Point Control and 250mV Start-Up. After exploring the IC’s internal block diagram, the evaluation board for this energy harvesting chip is presented. Various experiments, including the calculation of efficiency, maximum power delivery, start-up behavior and MPPC are presented. As a last experiment, a two stage energy harvesting setup using a solar panel and a super-capacitor capable of charging an iPhone is demonstrated.
The second IC of interest is the LTC3109 which is an Auto-Polarity, Ultralow Voltage Step-Up Converter and Power Manager Energy Harvesting chip. The block diagram and the evaluation board of this IC is presented. The ultra-low voltage capability of the circuit is demonstrated through the use of a Peltier cooler thermo-electric component to generate a 5V output voltage. As a final experiment, several ice cubes are used in conjunction with the thermo-electric generator in order to harvest enough energy to charge an iPhone for 30 seconds.
This is "The Signal Path dot com"! An electrical engineering video blog for students, hobbyists and hackers. I do equipment reviews, teardowns, circuit design tutorials, testing procedures and more! Subscribe to my RSS, join the community forum and participate in the discussions.